PD9105 TCMS Charge Wizard®

Charge Wizard for lead-acid and AGM type batteries.

The Charge Wizard PD9105 (for Lead-Acid and AGM type Batteries). This allows easy field upgrade to your PD9100 series deck mount converter/charger by simply plugging the Wizard into the built-in TCMS® connector located just above the fuses on the output panel. The Charge Wizard is a microprocessor-controlled unit that constantly monitors the RV battery voltage and then selects one of three charging voltages and one of four operating modes to properly re-charge and maintain the RV battery. The addition of the Charge Wizard makes your 9100 Series converter an intelligent battery charger that will safely and rapidly recharge a discharged battery by selecting the BOOST Mode (14.4V) of operation.

For reference only… No longer available

Once the battery reaches 90% of full charge, the Charge Wizardautomatically selects the NORMAL Mode (13.6V) to safely complete the charge. The STORAGE Mode (13.2V) is automatically selected after 30 hours of non-use of the 12-volt RV electrical systems. The lower charging voltage in the STORAGE Mode of operation reduces battery gassing and water usage, while maintaining the charge. Every 21 hours when the system is operating in the STORAGE Mode, the Charge Wizard will automatically switch to the EQUALIZATION Mode of operation. The EQUALIZATION Mode increases the charging voltage up to 14.4 volts for 15 minutes. This increased voltage mixes up the battery electrolyte and prevents battery stratification and the resulting problems of battery sulfation. View the literature.

The  above description applies to models with the Charge wizard function for Flooded and AGM lead acid batteries.

Models PD9200, PD9135, PD4000, PD4500 have these features built into the converter.

Charge Wizard Products

The PD9105V is no longer available.

Plugs into the accessory port of the PD9100 series converting it to a 4 stage charger.  Shows charger/converter status and allows for manual mode selection.

(for the 9200 series only)

The Button and Light function is  available as a pendant.  This allows easy field upgrade to your PD9200 series deck mount converter/charger by simply plugging the pendant into the built-in  receptacle on the side of the PD9200. Buy Now

What is the Charge Wizard?

Our patented Charge Wizard 4-stage system uses microprocessor technology to add intelligent charging capability. It constantly monitors the RV battery and automatically adjusts the converter output voltage based on the battery’s charge status – designed to eliminate battery over & under charging problems associated with most other battery chargers and provide rapid yet safe battery recharging after dry camping.

Wizard Guide by Converter Model

ModelLight and Button
Location
AccesoriesInstructions
PD9245
PD9260
PD9270
PD9280
Wizard is built into the 9200 and will run automatically. For Manual operation the Pendant is necessary. Light and Button are located on the Pendant Accessory.
PD92201 Pendant .
PD92201 Pendant
PD9130
PD9140
PD9145
PD9160
PD9170
PD9180
The Wizard is an optional accessory for these units. It is not included in the PD9100 series.
Light and Button are located on the Wizard Accessory. PD9105V ***This does not fit the Lithium series chargers.***
The PD9105V Wizard is no longer available as of June 2023
PD4635
PD4645
PD4655
Wizard is built into the PD4600 and will run automatically. For Manual operation the Light and Button are located on the Fuse Board . If not using our fuseboard there is a Pendant Accessory. available.
Here:SPD9220146
PD9130LV
PD9145ALV
PD9160ALV
PD9180ALV
2- Stage LiFePO4
For Manual operation the Pendant is necessary. Light and Button are located on the Pendant Accessory.
PD92201 Pendant .
***Will not work with Single stage models without the 2 stage sticker***
PD92201 Pendant